The recommended way to uncock a crossbow is by using an uncocking device. This device attaches to the string of the bow, and when activated will slowly release the tension in the bowstring, allowing you to safely remove it from its cocked position. To use this method effectively, ensure that your arrows have been removed…
The safest way to unload a muzzleloader is to always point the gun in a safe direction, away from anything you do not wish to damage or harm. First, make sure the firearm is unloaded by checking both ends of the barrel with your finger and visually inspecting it. Then, remove all ammunition from the…
Deer are typically found in wooded areas, including forests and thickets. As such, when shooting a deer with a crossbow it is important to choose the right location for maximum success. A good spot would be near known deer trails or food sources like acorns, berries and other vegetation that deer eat. It is also…
20 Inch 400 Grain Crossbow Bolts are specifically designed for crossbows and provide the shooter with a powerful bolt that is accurate and has increased penetration. These bolts feature an extra-large diameter, which increases their durability and accuracy. They also have a larger frontal surface area, making them more aerodynamic in flight and increasing their…
Muzzleloaders are firearms that use black powder as the propellant to fire a single projectile. Smokeless powder is not suitable for use in muzzleloaders because it burns too quickly and produces much higher pressures than black powder. This leads to increased wear on the gun, potentially causing damage or even catastrophic failure of the firearm….
The amount of time you can leave a crossbow drawn depends on the type and quality of your crossbow. Generally, modern compound or recurve crossbows should be able to stay cocked for around 30 minutes without losing accuracy or causing damage. However, traditional bows are not designed to be held at full draw for more…
It is generally advised to unload a muzzleloader and store it with the powder, balls, and patches removed. If you must keep a muzzleloader loaded for an extended period of time, such as for hunting or home defense purposes, it is recommended that the weapon be checked regularly to ensure that all components are still…
When cocking a crossbow, safety should be the top priority. Before beginning to cock, make sure the crossbow is facing away from any people or animals that may be nearby. Secondly, if you are using a rope-cocking device it should fit securely onto the bowstring and not move when pulling back on it. Once cocked,…
To adjust a crossbow scope, start by aiming the crossbow at a target and firing it. Measure the distance between where the bolt lands and your intended target. Then, remove the safety on the crossbow and cock it again with an arrow in place. Use a hex wrench to loosen or tighten each of the…
1. Ensure that the muzzleloader is unloaded; open the action and check for any ammunition in both chambers or the barrel, then remove it if found. 2. Place a small amount of powder into the breech with a powder measure, followed by one primer or percussion cap depending on your gun type. 3. Pour shot…